Standard parts are used for many technical components – even for those that actually have higher requirements. The quality or efficiency of the entire system can be increased by optimization.

Due to manufacturing in our corporate group, we are very flexible. Prototype manufacturing is as possible as low- and high-volume production. Thus, we are able to offer development and production from a single source.

In many cases, production steps can be simplified in order to reduce costs or increase quality. Due to our long-term experience, we have a broad knowledge of different manufacturing processes.

At Hagemann Systems, we think ahead. We also keep an eye on the designated use our clients schedule for our products. Other suppliers offer components. We offer complete systems –

In case a high component number is required, producing injection-molded parts is more economic, compared to other processes. By combining different technologies, we are even able to create shapes that normally would not be considered feasible.

By extrusion process, we produce seamless plates, pipes and profiles with constant cross-section over the whole length. Depending on the properties required by the component, we process a wide variety of plastics.

We manufacture deep-drawn components made of plastics or sheet metal which meet the highest quality standards. We are even capable of producing complex shapes such as covering caps for release clutches in railways.

Blow molding is a kind of advanced extrusion technology. This technology helps to very precisely produce plastic hollow bodies which have a thinner wall thickness than those produced in other processes. Depending on the purpose, we apply different materials.

We coat the most diverse materials. By dip coating, we refine surfaces, insulate electric conductors and preserve delicate materials from possible damage – and for an increased safety.